RJ45 STP Modular Plug cat. 6A/7, 1.5mm, with insert

The design of the body will not allow the use of any tool for crimping. Since the metal body of the connector completely encloses the side where space is often left under the "strain latch" cable retainer, it plays the role of holding the cable in the connector and relieving strain on the pins when pulled. This function is performed here by the shielded tail clip "Shielded Tail Clip"

Therefore, when crimping, it is possible to use only those tool models in which it is possible to deactivate the "strain latch" clamping function

Peculiarities:

• Ability to compress shielded twisted-pair category 6A, 7 (23 - 22 AWG).
  
• The insert allows crimping a conductor with an insulated wire diameter of 1.25 ≈ 1.5 mm.
• The presence of a through insert simplifies the installation of the connector.
• The connector has a metal cable support, providing load relief and shield contact.
• Trident shaped cutting knives.

• Type: 8P8C
  
• Category 6A (10 Gigabit Ethernet)
• The 50 micro-inch gold plating on the contacts ensures durability and reliable performance.
• Service life not less than 750 switching cycles.
• Overall length (mm) 22.5 (excluding cable support)
• Width (mm) 11.68
• Height (mm) 8.01 + lock
• Compatible wire gauge (AWG) 23-22
• Maximum conductor diameter with insulation 1.25 ≈1.5 mm
• The maximum outer diameter of a twisted pair is 7.5 mm
• Temperature range: -25℃～+55℃

Recommended installation tool:

1. HT-582QR Shielded Tail Clip, Change strain latch
2. LW-HT-002TB Tool for crimping 8P/RJ45 and 6P6C/6P4C, with ring clamp and switchable cable clamp